Application

NHV pumps are single stage, centrifugal, end suction pumps whit axial suction conector pipe and radial discharge connector pipe with horizontal shaft axis. Pump size and parameters according to PN-EN 733 standard. NHV pumps can pump media not containing abrasive inclusions. Media physical and chemical properties should range within corosion resistance limits for materials used for pump construction in a specific material version. there are following material versions of the pumps available : made of grey cast iron, bronze or austenitic cast steels.

MV type single stage, centrifugal end suction, pumps in monoblock arrangement, whit the pump and engine impeller mounted on the same shaft. The pump and the engine operate on the same bearing system. The bearing system. the bearings are covered on both sides and filled whit lubricant for the time of operation. MV pumps are suitable for pumping clean, non-flammeble and non-explosive liquids, containing no solids or long-fibre components. the corrosive power of the pumps medium ought to range whitin the corrosion resistance limits applicable to the materials used for the given pump construction. the following material versions of the pumps are available : grey cast iron bronze, austenitic cast steel.

Pumps Are used in :
Water supply systems and water work.
Industry (pressure boosting system, cooling system, process water circulation system)
Thermal-electric power stations.
Industrial cooling systems.
Agriculture (irrigation systems).
Fire-fighting system, hydrants.
Fuel and Highly aggressive liquid pumping systems.
Chemical instalation.
Environmental engineering.


Price by phone

Deep-Well Pumps

Application

Deep Well Pumps are designed for pumping of dringking water, treated water, raw water, and sea water as well as mineral and thermal waters not containing long, abrasive fibres elements. maximum sand content in the pumping water is 50 - 100 g/m3. Well pumps are designed for pumping of water from well of 4", 6", 8", 10", 14" diameter minimum. Pumps are mainly installed in borehole wells where the dynamic water level at pumping water capacity is known. The capacity of the well should be bigger then maximum output of the pump.

Pumps are used in :
Water supply system.
Pumping system and liquid pressure boosting system used in technological processes.
System use for lowering the ground-water level.
Irigation system.

Type deep-well pumps are, among other, characterized by :
Modern design solutions.
Guaratee of long-standing, reliable operation.
Relative low cost of purchase comparing to quality as well as low operation.
1 years guarantee in indonesian.
The complete manufacturing process of pumps takes pleace in the parent factory, which guanrantees flexible deliveries and quickly accessible spare parts,.
Rewindable motors.
Motors can be optionally equipped whit temperatur sensor.
Coupling of the pumps whit the engine as per the NEMA standard allows for flexibility during engine selections.
Relatively high durability in difficult operating conditions.
Pumping sets may be delivered equipped whit hermetically sealed jackets and suction jackets.

Material Versions :
Shaft and coupling - stainless steel.
Middle casing - stainless steel or allow cast iron.
Central casing - cast iron or copper cast iron or bronze.
Casing - cast iron or ductile cast iron or bronze.
Body - stainless steel or allow cast iron or brass.
Impeler - plastic combined whit brass or brass or bronze or noryl.


Price by phone